ARCHIVED

Description

The DPT 115 is a light weight pan & tilt head designed to carry a variety of load configurations. The digital design of the DPT 115 allows flexibility in lens selection and the adapability necessary for special requirements. Teleconferencing, ENG and CCTV lenses may all be easily interfaced to the versatile DPT 115.

Presets are available on the DPT 115 for pan, tilt, zoom, and focus. The resolution of the presets is 12 bits giving an angular resolution of 0.1 degree.

DIP Switches located at the base of the unit make special functions and configuration changes easily implemented.

The Model 180 family of digital controllers was specifically designed to get the most from a DPT 115.

Other Applications

• City Council Chambers
• County Commission Meetings
• Auditoriums and Classrooms
• Teleconferencing Rooms
• Meeting Rooms and Boardrooms

MODEL 180 DIGITAL CONTROL UNIT

The Model 180 can provide pan & tilt and lens control for up to 4 remote camera sites. Sixteen presets per camera site may be selected from the Model 180. The digital design of the Model 180 allows custom controls to be included for unique customer requirements. These control functions may be activated via the 2 auxiliary switches located on the Model 180 front panel.

The pan and tilt control is provided by a proportional deflection joystick. Control of the zoom and focus is accomplished with proportional deflection "Seesaw" controls. The proportional controls allow a slow movement when the control is only slightly depressed and a much faster response when the control is more fully depressed.

An externally accessible DIP switch at the rear of the unit allows pan, tilt, and lens control reversal.

The versatile digital interface of the Model 180 to the DPT 115 allows a variety of camera/lens combinations to be controlled by a single Model 180. In addition, Options such as; Iris control or control of more than 4 remote camera sites may easily be implemented.

The Model 180 table top version features a sloped front panel for ready access to all of the Model 180 controls.

Four RS-422 connectors are located on the rear of the unit to interface to each of the 4 remote camera sites. A 9 Pin D connector located on the rear of the Model 180 provides the RS-232 serial interface for computer input/output. Input power to the Model 180 is provided by a wall mounted power supply which is provided with the unit.